Worked, unit-aware calculation worksheets across structural, mechanical, electrical and more. Open any example into your own workspace to edit and reuse. New to Calculeaf? Start with your first worksheet or the examples guide.
55 examples found
Peak EMF of a rotating coil generator.
Force on a conductor carrying current in a magnetic field.
Magnetic flux density inside a long solenoid.
Charge stored on a capacitor at a given voltage.
Magnitude of impedance of a series resistance and reactance.
Power dissipated in a resistor from the current through it.
Electric charge transferred by a steady current over time.
Resistance of a conductor at a new temperature via its temperature coefficient.
Unknown resistance from a balanced Wheatstone bridge.
Energy stored in a battery from its charge capacity and voltage.
Electrical power from a solar panel given irradiance, area and efficiency.
Voltage drop along a single-phase circuit from conductor resistance, current, and length.
Available short-circuit fault current from system voltage and total fault impedance.
Allowable cable current-carrying capacity after applying temperature and grouping correction factors.
Approximate transformer voltage drop under load expressed in per-unit impedance terms.
Reactive power (kVAR) a capacitor bank must supply to raise a load’s power factor to a target value.
Inrush current an induction motor draws at the instant of starting, before it comes up to speed.
Minimum breaker rating for a continuous load using the standard 125% continuous-load rule.
Resistance to earth of a single driven ground rod electrode from soil resistivity and rod dimensions.
Apparent power rating of a three-phase transformer from line-to-line voltage and line current.
Voltage drop expressed as a percentage of nominal voltage for a quick feeder compliance check.
Number of solar panels needed to meet a daily energy target given peak sun hours and system efficiency.
Battery bank capacity in amp-hours needed to power a backup load for a target duration.
Time needed to recharge a battery from its amp-hour capacity and the charger’s current output.